I've been using "UnderCoverXP" on "DVD Box," settings to print my covers and I'm noticing that the covers are usually about 1cm too small length wise for my cases, the cover doesn't completely cover the case. Is there anyway to get around this?

Did you use the correct paper settings?I had the same problem with that program because it was defaulting to some silly size paper, and not the A4 i was using.

:thumbup:

Sometimes I get an error that says "the image is (partly) outside of your printers printable area, it will be scaled to fit properly," or something to that affect, would that be the problem? I'm thinking maybe it is scaling it down too small, because even though it's too large there is still spaces of white I have to cut off.

Note..I'm using 8.5 x 11 sized paper.